Qualstar 501440 Rev. G Manual

A SERVICE OF

next previous

5. Using a Phillips screwdriver, secure the FCO to the rear of the library at the

FCO’s two top captive screws. See Figure 4-5.

6. Using two of the screws that were removed with the service panel, attach the

FCO’s two hinges to the rear of the library. See Figure 4-5.

Bottom Edge of

Service Panel Opening

Heatsink Panel

Screws (4)

Captive Screws (4)

FCO’s

Hinges (2)

Fibre Channel

Option

Executive PCBA

Screw Holes (6)

Figure 4-5 Rear View of TLS

7. Loosen the two top captive screws on the FCO that were tightened in step num-

ber four. Carefully guide the FCO backwards as it pivots on the hinges and

comes to its open position. See Figure 4-6.

FCO in Open Position

Figure 4-6 Fibre Channel Option in the Open Position

501440 Rev. G FCO Type A Installation 4-5