11. For TLS-44xx, 46xx and 412xxx libraries only, connect the SCSI Bus ribbon ca-
ble from the farthest away set of tape drives (labeled CH2) to the CH2 connector
on the Fibre Channel Option. For TLS-42xx, 44xx, 46xx and 412xxx libraries
only, connect the SCSI Bus ribbon cable from the nearest set of tape drives (la-
beled CH1) to the CH1 connector on the Fibre Channel Option. See Figure 4-10.
Skip to step 12.
12. For TLS-62xx and 82xx libraries only, connect the SCSI Bus ribbon cable (la-
beled CH1) from connector 2 as seen in Figure 4-1 to the CH1 connector on the
Fibre Channel Option. See Figure 4-10. Skip to step 12.
13. For TLS-54xx, 58xxx, 64xx, 68xxx, 84xx and 88xxx libraries only, connect the
SCSI Bus ribbon cable (labeled CH2) from connector 2 as seen in Figure 4-2 to
the CH2 connector on the Fibre Channel Option. Connect the SCSI Bus ribbon
cable (labeled CH1) from connector 1 as seen in Figure 4-2 to the CH1 connector
on the Fibre Channel Option. See Figure 4-10.
CH2 Connector
CH1 Connector
CH0 Connector
Figure 4-10 Channel Connections
14. Finally, connect the SCSI Bus ribbon cable (labeled CH0) from the SE/LVD or
LVD/SE (Executive PCBA version dependent) connector on the Executive PCBA
to the CH0 connector on the Fibre Channel Option. See Figure 4-10.
15. Carefully lift the FCO until it touches the rear of the TLS. Using a Phillips
screwdriver, secure the Fibre Channel Option to the rear of the TLS by tighten-
ing all four of the captive screws. Refer to Figure 4-5 for captive screw locations.
501440 Rev. G FCO Type A Installation 4-9
