Connectors on Rear of FCO Connectors on Rear of
TLS-58xxx, 68xxx and 88xxx
SCSI Channel 0 Left Medium Changer
Left Tape Drive 1 (LT1)
Left Tape Drive 2 (LT2)
SCSI Channel 1 Left Tape Drive 3 (LT3)
Left Tape Drive 4 (LT4)
SCSI Channel 2 Right Tape Drive 1 (RT1)
Right Tape Drive 2 (RT2)
SCSI Channel 3 Right Tape Drive 3 (RT3)
Right Tape Drive 4 (RT4)
Serial DB9 (Right Executive IV, SERL A)
Table 5-3 Preferred Fibre Channel Option Cable Connections
The following steps outline the actions necessary to connect the cables from the FCO
to the TLS. Please see Figure 5-4 and Figure 5-5.
1. Remove power from the TLS: first turn the power switch off and then remove the
power cord.
2. Remove power from the FCO: first turn the power switch off and then remove
the power cord.
3. Connect a SCSI Cable from the SCSI Channel 0 connector on the FCO to connec-
tor A on the left side on the TLS.
4. Connect a SCSI Bridge Cable (very short cable) from connector B to C.
5. Connect a SCSI Bridge Cable from connector D to E.
6. Connect a SCSI Cable from the SCSI Channel 1 connector on the FCO to connec-
tor G.
7. Connect a SCSI Bridge Cable from connector H to I.
8. Attach a terminator at connectors F and J.
9. Connect a SCSI Cable from the SCSI Channel 2 connector on the FCO to connec-
tor K on the right side on the TLS.
10. Connect a SCSI Bridge Cable from connector L to M.
11. Connect a SCSI Cable from the SCSI Channel 3 connector on the FCO to connec-
tor O.
12. Connect a SCSI Bridge Cable from connector P to Q.
13. Attach a terminator at connectors N and R.
5-6 FCO Type B Installation 501440 Rev. G
