5
ADVANCED
CONFIGURATION
Advanced Configuration Parameter Default Values
To change advanced configuration parameter values, you
will need terminal emulation software to allow you to use
AT commands.
For Windows 95 and Windows NT users, HyperTerminal
terminal emulation software is provided with those
operating systems. For Macintosh users, terminal emulation
software was installed in the 3ComImpact IQ folder during
software installation.
The advanced configuration parameters and their default
settings are as follows:
■ Auto Answer (disabled)
■ Baud Rate (automatic detection of rates up to 115.2 Kbps)
■ Compression (enabled)
■ Dynamic Bandwidth Allocation (enabled)
■ QuickSelect (enabled)
Each parameter is described in detail in the following section.
If the default settings meet your preferences, go on to
Chapter 6, “Placing and Receiving Calls.”