Filter
Top Products
116 CHAPTER 6: CONFIGURING PORTS
Defining Port
Settings
The Port Administration Setup Page allows network managers to
configure port parameters for specific ports.
Monitor users have no access to this page.
When using auto-negotiation to set the port speed or duplex mode, it
must either be enabled for both parameters (Auto) or set to a fixed mode
(10/100/1000, Half/Full).
The 1000BASE-T standard does not support forced mode. Auto-
negotiation should always be used to establish a connection over any
1000BASE-T port or trunk. If not used, the success of the link process
cannot be guaranteed.
To configure Port Settings:
1 Click Port > Administration > Setup. The Port Administration Setup
Page opens:
Figure 59 Port Administration Setup Page