Filter
Top Products
Default Users and Passwords 33
To display and configure SNMP management parameters, refer to
“Configuring SNMP” on page 163.
Default Users and
Passwords
If you intend to manage the switch or to change the default passwords,
you must log in with a valid user name and password. The switch has two
default user names. The default users are listed in
Table 5.
Use the admin default user name (no password) to log in and carry out
initial switch setup.
Changing Default
Passwords
You can change the default passwords using either:
■ The username command on the CLI, or
■ The Administration > System Access > Modify operation on the web
interface.
Upgrading
Software using the
CLI
This section describes how to upgrade software to your switch from the
Command Line Interface (CLI).
Note: You can also upgrade the software using the switch Web user
interface. See “Restoring the Software Image” page 197. Bootcode can
only be upgraded using the CLI, for which instructions are supplied in the
release notes.
1 To download the runtime application file, enter the following commands:
Console#copy tftp file
TFTP server IP address: aaa.aaa.aaa.aaa
Choose file type:
1. config: 2. opcode: <1-2>: 2
Source file name: rrr
Destination file name: rrr
Tabl e 5 Default Users
User Name
Default
Password
Access Level
admin (no password) Management — The user can access and change
all manageable parameters
monitor monitor Monitor — the user can view all manageable
parameters, but cannot change any manageable
parameters