Filter
Top Products
Example
The following example configures port 2 of the 6412M-25-TP module installed in slot 1.
ONcoreATM> set port 1.2 uni [ENTER]
ONcoreATM> Port set.
ONcoreATM> show port 1.2 verbose [ENTER]
Type Mode Status
-------------------------------------------------------------------------------
1. 2:UNI enabled UP-OKAY
Signalling Version : with ILMI
Flow Control : Off
Connector : RJ-45
Media : copper twisted pair
Remote device is active
IX status : IX OK
Port speed : 256 Kbps
ONcoreATM>
Displaying Configuration Settings
The following sections describes how to display information about the module and its
port configurations. By displaying this information, you can check that the module is
properly configured before connecting it to the network.
Module Information
To display status information about a 6412M-25-TP module, use the SHOW MODULE
command.
Chapter 3. Configuration 3-3