Filter
Top Products
60
table and re-enable BootP on the port waiting for the IP address. BootP must be
re-enabled before route update are received.
Remote Access
Default Change
To increase network security, the default value for the NetAccess parameter in the
SYS Service is set to NoRemote. This means that by default, no remote connection
attempts will be accepted by the bridge/router. If you are accustomed to or want
to use remote access, you must specifically set the value of the NetAccess
parameter to Remote.
Scheduler
RunOnBootFail
Completion
When RunOnBootFail is specified, event-based macro execution (EBME) is enabled
when the primary connections fail to establish within 5 minutes after the switch
boots. After the initial 5 minutes, PortDown event processing happens at the rate
of approximately one port per second. When the PathBuilder S5xx series switch is
configured for 2048 virtual ports it takes about 45 minutes after the system
initializes for the RunOnBootFail processing to be completed on all ports.
V.25bis Modem Setup If you are using a V.25bis modem with a NETBuilder boundary routing leaf node,
and you configure the line type explicitly as dial rather than auto, be certain to also
set the DialMode to V.25bis rather than use the default of DTR.
Web Link
Documentation Path
When you set the DocumentPath parameter in the WebLink service to a local file,
drive C for example (“file:///c:”), the Web Link assumes that access to the
NETBuilder bridge/router takes place only from the computer to which the file is
local. If Web Link is used from any other computer, the browser looks on its local
“C” drive for the help pages. If the computer is a UNIX machine and these files are
not present as expected, unpredictable browser behavior will result.
Web Link Login Support When you access the Web Link application for the first time, you are prompted to
enter a username and password. This username and password remains valid on
the NETBuilder bridge/router for two hours. Because most browsers cache user
login information, it is recommended that you log out of Web Link by selecting
the “Logout” icon on the home page.
Zmodem Time Out A Zmodem file transfer from a PC to a SuperStack II or OfficeConnect
bridge/router can take a long time. To minimize the possibility that the PC
Zmodem software will time out during the download, run the DEFRag command
on the SuperStack II bridge/router before beginning the file transfer. The DEFRag
command reclaims dirty space in flash memory. Dirty space is memory that has
been written on and cannot be used again until it has been erased.
VPN Protocols and
Services Notes
This section describes notes, cautions, and other considerations to be aware of
when using the Enterprise OS software with VPN protocols and services. The
topics are presented in alphabetical order.
ACE Security Server When interoperating with the ACE Security Server for Token-based login support,
you may need to change the RAS Retransmit Timer value to a higher value (for
example, 7) to prevent access-request time-outs.
Total Control Security
and Accounting Server
Availability
The Total Control™ Security and Accounting Server provides call authentication,
authorization, and accounting for your Enterprise OS devices. At the time of
publication of these release notes, the required version number of the SAS server