Filter
Top Products
3-20 CHAPTER 3: NOVELL NETWARE ENVIRONMENTS
Installing the Driver as Part of a New Server
Installation or Upgrade to NetWare 4.1x
This section has instructions for loading TLNKPODI.LAN as
part of a new NetWare server installation or an upgrade to
NetWare 4.1x. The procedure shows the essential steps for
installing the server driver only. For most installations, other
steps will be required; consult your Novell documentation
for information about any procedures not described below.
1 At the Load LAN Driver menu, insert TokenDisk
diskette #1 into the drive and press Alt+Esc to switch
from the Install program to the server console
command prompt.
2 Enter the following commands at the server console
command prompt:
unload tokentsm
unload msm
3 From TokenDisk diskette #1, load the support modules
required to run the server driver. Enter the following
commands at the server console command prompt in
the order shown:
load a:\netware\nwserver\4.1x\msm
load a:\netware\nwserver\4.1x\tokentsm
Typically, the modules that ship with NetWare 4.1x are an
earlier version than 2.50. It is recommended that you use
MSM.NLM and TOKENTSM.NLM version 2.50 or later with
TLNKPODI.LAN.
4 Press Alt+Esc to return to the Install program.
5 Press Insert to load an unlisted LAN driver, and then
follow the prompts to specify the driver load path.
6 At the next menu, enter the following path:
a:\netware\nwserver
After a short delay, a menu appears, showing the
TLNKPODI.LAN driver.
7 Press Enter to select the TLNKPODI.LAN driver.
8 When asked if you want to copy the driver (to
SYS:SYSTEM), respond Yes.
The next menu shows the parameters that can be used
with the 3C359 token ring NIC driver.
Book Page 20 Saturday, November 1, 1997 3:13 PM