Filter
Top Products
Configuring IBM Host Connectivity 5-5
12 Click Exit in the MPTS dialog box.
13 Click Exit in the Update CONFIG.SYS panel to update
the CONFIG.SYS file.
14 When you get the message that the CONFIG.SYS file
has been successfully updated, click OK.
15 Click Exit in the Exiting MPTS panel.
16 If you are using the 3.5-inch TokenDisk diskettes,
insert TokenDisk diskette #1 in the drive.
17 Copy the microcode file TLNKP.MAC from the
TokenDisk to your hard drive. For example, enter:
copy a:\tlnkp.mac c:\ibm\macs
If you are using the TokenDisk CD, substitute the
appropriate drive in the microcode file’s path.
18 Shut down OS/2 and restart your computer to let the
changes take effect.
19 At system startup, check for the following conditions
to determine whether the NIC is working correctly and
whether installation has been completed successfully:
■ The device driver files loaded successfully. There are
no error messages.
■ You are able to log on and communicate with
the network.
If you experience problems, see Chapter 6,
“Troubleshooting.”
Installation of the driver for OS/2 is now complete.
Configuring IBM Host Connectivity
This section describes the initial phase of configuring
3C359 NIC connectivity to an IBM host computer
(mainframe or AS/400) for various Windows environments.
This phase involves adding the appropriate network
protocol to enable host connectivity.
After adding the network protocol, install the host
connectivity applications (such as client access and
emulator applications) that are appropriate for your
environment.
Book Page 5 Saturday, November 1, 1997 3:13 PM