Filter
Top Products
Installing a NetWare Server Driver 3-21
9 Press Enter to view a list of supported options for the
selected parameter.
Additional help for the parameter is also displayed in the
lower text box. You can also find a description of parameters
and explanations earlier in this chapter in “Using the Load
Command.”
10 After you have made selections for all 3C359 NIC
driver parameters, press F10 to save the parameters
and load TLNKPODI.LAN. Then follow the prompts to
complete the server installation.
11 After completing the installation, copy the support
modules MSM.NLM and TOKENTSM.NLM from
TokenDisk diskette #1 to the server’s SYS:SYSTEM
directory.
Doing so causes the support modules to be auto-loaded
by any of the server drivers, such as TLNKPODI.LAN. See
“Copying Support Modules and the Driver to the
File Server” earlier in this chapter for instructions.
Unbind and Unload Commands You can use the
Unbind or Unload commands to remove a driver (or logical
board). The commands have the format shown below:
unbind ipx tlnkpodi <name>
unload tlnkpodi
The Unbind command requires only that you reenter
the Bind command, and does not affect the Load
command. You can selectively unbind a protocol for a
particular logical board by specifying a board name, as
shown in the command sample.
The Unload command completely unloads the driver from
memory. If you wish to reload the driver, you will be
required to use the Load and Bind commands.
Book Page 21 Saturday, November 1, 1997 3:13 PM