Filter
Top Products
40 Chapter 2
1.
Move the cursor and highlight the Set Supervisor Password and press “
Enter
”
,
a window similar to the
following is shown:
2.
Type a password in field “
Enter New Password
”. The password length can not exceeds 8 alphanumeric
characters (0-9 or A-Z / a-z, not case sensitive). Re-enter password in field “
Confirm New Password
” for
verification.
3.
If the verification is OK, a window similar to the following is shown, press enter to complete.
After setting the password, the computer sets the Password parameter to "Set".
4.
If desired, you can opt to enable the Password on boot parameter.
5.
When you are done, press F10 to save the changes and exit the BIOS Setup Utility.
IMPORTANT:
Be very careful when typing your password because the characters do not appear on the
screen.
If the current password entered does not match the actual current password:
If the new password and confirm new password strings do not match:
SG_TM800.book Page 40 Thursday, February 27, 2003 10:21 PM