Filter
Top Products
89
Installing Windows NT 4.0 and Windows 2000
Drivers
Use the following procedure to install the IDE Software RAID Windows
NT 4.0 or IDE Software RAID Windows 2000 driver on to the RAID-
configured drives connected to the primary or secondary IDE channel.
Updating the Windows NT 4.0 or Windows 2000
Driver
Use the following procedure to update the IDE Software RAID
Windows NT 4.0 or IDE Software RAID Windows 2000 driver or install
the IDE Software into an existing system booted from a standard IDE or
SCSI drive controller.
Step Description
1 Boot the system with the Windows NT or Windows 2000 Boot Installation CD
or diskette.
2 Press <F6> when the following message is displayed:
“Setup is inspecting your computer hardware
configuration.”
3 When installation prompts for a key after copying some files, press <S> to
add a SCSI adaptor.
4 Select Other from the list displayed on-screen.
5 Insert the IDE Software RAID driver floppy diskette and press <ENTER>.
6 Select LSI Logic IDE Software RAID driver from the list and click OK.
7 Continue with the installation process.
Step Description
1 Click on the Windows Start button. The Windows menu is displayed.
2 Select Settings.
3 Click on Control Panel.
aa300.book Page 89 Tuesday, December 17, 2002 5:27 PM