Filter
Top Products
Setup Utility 2-7
2.2.10 IDE Secondary Channel Slave
This parameter specifies the current configuration of the IDE device
connected to the slave port of the secondary IDE channel. For
information on how to configure the IDE drives, see section 2.4.3.
2.2.11 Total Memory
This parameter specifies the total amount of onboard memory. The
memory size is automatically detected by BIOS during the POST. If
you install additional memory, the system automatically adjusts this
parameter to display the new memory size.
1st Bank/2nd Bank/3rd Bank
The 1st Bank, 2nd Bank, and 3rd Bank parameters indicate the type
and size of DRAM installed in DIMM sockets 1, 2, and 3 respectively.
The None setting indicates that there is no DRAM installed. For the
location of the DIMM sockets, refer to Figure 1-1.
2.2.12 Serial Port 1
This parameter shows the serial port 1 address and IRQ setting.
2.2.13 Serial Port 2
This parameter shows the serial port 2 address and IRQ setting.
2.2.14 Parallel Port
This parameter shows the parallel port address and IRQ setting.