Filter
Top Products
iii
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
FCC Regulatory Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's author-
ity to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a specific installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, try to correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and the receiver.
3. Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used with this product to ensure compliance
with the Class B FCC limits.
Model Number: Series 520
Disclaimer – LSI LOGIC certifies only that this product will work correctly when
this product is used with the same jumper settings, the same system
configuration, the same memory module parts, and the same peripherals that
were tested by LSI LOGIC with this product. The complete list of tested jumper
settings, system configurations, peripheral devices, and memory modules are
documented in the LSI LOGIC Compatibility Report for this product. Call your LSI
LOGIC sales representative for a copy of the Compatibility Report for this
product.