Filter
Top Products
BIOS Boot Error Messages 7-3
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
7.2 BIOS Boot Error Messages
Table 7.2 describes error messages that can display when you boot the
system, and suggested solutions.
Table 7.2 BIOS Boot Error Messages
Message Problem Suggested Solution
Adapter BIOS Disabled.
No Logical Drives
Handled by BIOS
The MegaRAID BIOS is
disabled. Sometimes the
BIOS is disabled to
prevent booting from the
BIOS.
Enable the BIOS using the MegaRAID BIOS
Configuration Utility.
Host Adapter at
Baseport xxxx Not
Responding
The BIOS cannot
communicate with the
adapter firmware.
Make sure MegaRAID SCSI 320-0 is properly
installed.
No MegaRAID SCSI
320-0 Adapter
The BIOS cannot
communicate with the
adapter firmware.
Make sure MegaRAID SCSI 320-0 is properly
installed.
Configuration of
nonvolatile RAM
(NVRAM) and drives
mismatch.
Run View/Add
Configuration option of
Configuration Utility.
Press any key to run the
Configuration Utility.
The configuration stored
in the MegaRAID SCSI
320-0 adapter does not
match the configuration
stored in the drives.
1. Press a key to run MegaRAID Manager.
2. Select View/Add Configuration from the
Configure menu.
3. Use View/Add Configuration to examine
both the configuration in NVRAM and the
configuration stored on the disk drives.
4. Resolve the problem by selecting one of the
configurations.
1 Logical Drive Failed A logical drive failed to
sign on.
Make sure all physical drives are properly
connected and are powered on.
Run MegaRAID Manager to find out if any
physical drives are not responding. Reconnect,
replace, or rebuild any drive that is not
responding.
X Logical Drives
Degraded
x number of logical
drives signed on in a
degraded state.
Make sure all physical drives are properly
connected and are powered on.
Run MegaRAID Manager to find if any physical
drives are not responding. Reconnect, replace,
or rebuild any drive that is not responding.