Filter
Top Products
Installation Steps 6-3
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
· The Driver and Documentation CD, which contains these items:
– The MegaRAID Configuration Software Guide
– The MegaRAID Operating System Driver Installation Guide
– The MegaRAID SCSI 320-0 ZCR Hardware Guide
– The software license agreement
– The MegaRAID SCSI 320-0 configuration utilities for DOS
· The warranty registration card
6.2.2 Step 2: Power Down
Turn off the computer, remove the power cord, then remove the cover.
Make sure the computer is turned off and disconnected from any
networks before installing the controller card.
6.2.3 Step 3: Set Jumpers
Make sure the jumper settings on the MegaRAID SCSI 320-0 card are
correct. The jumpers are set at the factory and you probably do not need
to change them. Table 6.2 lists the jumpers (and a connector).
Figure 6.1 shows the location of these items on the MegaRAID SCSI
320-0 controller.
Table 6.2 Jumpers for the MegaRAID SCSI 320-0
Item Description Type
J2 Dirty cache LED 2-pin header
J3 Clear EPROM 2-pin header
J4 BIOS enable 2-pin header
J8 BBU daughter card connector 40-pin connector