Filter
Top Products
6-6 Hardware Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Figure 6.3 Installing the MegaRAID SCSI 320-0 Controller
6.2.5 Step 5: Power Up
Replace the computer cover and reconnect the AC power cords. Turn
power on to the host computer. Set up the power supplies so that the
SCSI devices are powered up at the same time as or before the host
computer. If the computer is powered up before a SCSI device, the
device might not be recognized.
During boot, the MegaRAID SCSI 320-0 BIOS message appears:
MegaRAID SCSI 320-0 Disk Array Adapter BIOS Version x.xx
date
Copyright (c) LSI Logic Corporation
Firmware Initializing... [ Scanning SCSI Device ...(etc.)... ]
Bracket Screw
64-Bit Slots
(5 V)
32-Bit Slots
(3.3 V)