Filter
Top Products
32 Chapter 2
The following table describes the parameters in this screen. Settings in boldface are the default and
suggested parameter settings.
Setting the Boot Drive Sequence
The Boot Drive Sequence section lists boot priorities (1st, 2nd, 3rd and 4th) for bootable drives in your
computer.
For example, the default value (1st:Floppy Disk, 2nd:CD-ROM, 3rd:Hard Disk and 4th:LANDesk (R) Service
Agent) tells the computer to first search for a bootable floppy disk in the floppy drive. If it finds one present, it
boots up from that floppy disk. If not, the computer continues to search for a bootable CD-ROM in the CD-
ROM drive. If it cannot boot up from the CD-ROM drive, it continues by booting up from the hard disk.
To set the boot drive sequence, use the cursor up/down keys to select a priority level (1st, 2nd, 3rd and 4th),
then use the cursor left/right keys to select the device for that priority level.
Parameter Description Options
Boot Display Sets the display device on boot-up.
When set to
Auto
, the computer automatically
determines the display device when the computer
starts up. If an external display device (e.g., monitor)
is connected, it becomes the boot display; otherwise,
the computer’s display screen is the boot display.
When set to
Both
, the computer outputs to both the
computer display screen and an external display
device if one is connected.
Both
or Auto
Screen Expansion When set to enabled, the screen will automatically
adjust the display to fit the screen when the resolution
is set to 640 x 480.
Enabled
or Disabled
Resume on LAN/Modem Access When enabled, it allows your computer to resume
when LAN/Modem access is active.
Enabled
or Disabled
Hotkey Beep When enabled, the computer gives off a beep when a
hotkey (key combination is pressed).
Enabled
or Disabled
Fast Boot Allows you to define your system’s booting process;
whether to skip some POST routines or proceed with
the normal booting process.
Enabled
or Disabled
Boot Drive Sequence Specifies the order in which the computer starts up
from. See the section below.
1st: Floppy Disk,
2nd: CD-ROM,
3rd: Hard Disk
4th: LANDesk (R) Service
Agent