Filter
Top Products
Appendix
107
Question Answer
The printer does
not work.
Do the following:
❑ Make sure that the printer is turned on and is
connected to a power outlet.
❑ Make sure the printer cable is connected
securely to the computer’s parallel port and to
the corresponding port on the printer.
❑ Press Fn+F3 to reconfigure Plug-and-Play
devices.
❑ Press Fn+F2 to enter the BIOS setup utility.
Select About My Computer, press Enter, and
then press PgDn to go to page 2. Check if the
Parallel Port is enabled. If it is disabled, go to
page 3 of the Advanced System Configuration
(see page 91) and set the parallel port
parameters as described on page 93.
No sound comes
out of the computer
speakers.
Check the following:
❑ The speakers may be muted. Press Fn+F6. If
the pop-up does not contain a speaker icon,
press Fn+F7 to turn on the speakers.
❑ The volume level may be too low. Press
Fn+Ctrl+
↑ to increase the volume.
❑ If headphones or external speakers are
connected to the line-out port on the
computer’s left panel, the internal speakers are
automatically turned off.
❑ Onboard audio may be disabled. Press Fn+F2
to enter the BIOS setup utility. Select About
My Computer, press Enter, and then press
PgDn to go to page 2. If onboard audio is
disabled, go to page 3 of the Advanced System
Configuration (see page 91) and change the
onboard audio setting to Enabled.