Filter
Top Products
System Tour
30
1. If the floppy drive module is installed in the
module bay, remove it by following the steps
described in the next section.
2. Open the port cover on the rear of the
computer, and connect the 25-pin connector
end of the floppy drive cable to the computer’s
parallel port.
3. Connect the other end of the cable to the floppy
drive module.
Swapping Modules
The TravelMate 7300 Series notebook computer
allows you to hot-swap modules in and out of the
module bay. With hot-swap functionality, you do
not need to turn off your computer or put the
computer in suspend mode to swap modules.
The module bay icon located on the taskbar of
your Windows 95 desktop shows what device is
currently installed in the module bay: