Filter
Top Products
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7189
1U Rackmount System
CHAPTER 2 INSTALLATION
2-1 Overview
This chapter provides a quick setup checklist to get your Acnodes RMC7189 and running. Following
the steps in the order given should enable you to have the system operational within a minimal amount
of time. This quick setup assumes that your RMC7189 system has come to you with the processor and
memory preinstalled. If your system is not already fully integrated with a motherboard, processor,
system memory etc., please turn to the chapter or section noted in each step for details on installing
specific components.
2-2 Unpacking the System
You should inspect the box the Acnodes RMC7189 was shipped in and note if it was damaged in any
way. If the server itself shows damage, you should file a damage claim with the carrier who delivered it.
Decide on a suitable location for the rack unit that will hold the Acnodes RMC7189. It should be situ-
ated in a clean, dust-free area that is well ventilated. Avoid areas where heat, electrical noise and
electromagnetic fields are generated. You will also need it placed near a grounded power outlet. Read
the Rack and Server Precautions in the next section.
2-3 Preparing for Setup
The box the RMC7189 was shipped in should include two sets of rail assemblies, two rail mounting
brackets and the mounting screws you will need to install the system into the rack. Follow the steps in
the order given to complete the installation process in a minimum amount of time. Please read this
section in its entirety before you begin the installation procedure outlined in the sections that follow.
Choosing a Setup Location
o Leave enough clearance in front of the rack to enable you to open the front door completely (~25
inches)and approximately 30 inches of clearance in the back of the rack to allow for sufficient airflow
and ease in servicing. This product is for installation only in a Restricted Access Location (dedicated
equipment rooms, service closets, etc.).
o This product is not suitable for use with visual display work place devices accord- ing to §2 of the the
German Ordinance for Work with Visual Display Units.