Filter
Top Products
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2005 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7189
1U Rackmount System
PCI SERR Signal Type (Available when PCI SERR Function is enabled.)
System Monitoring Interface (SMI) and Non-Maskable Interrupt (NMI) are different signal interfaces in
the serverboard that handles system errors. The options are [NMI], and [SMI].
PCI-E Slot from SXB1/PCI-E Slot from SXB2/PCI-E Slot from SXB3
Select Enabled to enable PCI-E SXB1 slot, PCI-E SXB2 slot or PCI-E SXB3 slot. It can also enable
Option ROMs to boot computer using a network interface from these slots. (SXB1, a x16 slot, can be
configured into two x8 slots. SXB2, a x8 slot, can be configured into two x4 slots.) The options are
Enabled and Disabled.
Onboard LAN Option ROM Select
Select iSCSI to use iSCSI Option ROMs to boot the computing using a network device. Select iSCSI
to use PXE Option ROMs to boot the computing using a network device. The options are iSCSI and
PXE.
Load Onboard LAN1 Option ROM/Load Onboard LAN2 Option ROM
Select Enabled to enable the onboard LAN1 or LAN2 Option ROM. This is to boot the computer
using a network interface. The options are Enabled and Disabled.
XSuper IO Device Configuration
Uart 2 of Hermon as
Select COM to configure the onboard COM 2 port as a normal serial port. Select SOL to configure
the onboard COM 2 port as a virtual COM port for SOL use. The options are SOL and COM.
Serial Port 1 Address/ Serial Port 2 Address
This option specifies the base I/O port address and the Interrupt Request address of Serial Port 1
and Serial Port 2. Select Disabled to prevent the serial port from accessing any system resources.
When this option is set to Disabled, the serial port physically becomes unavailable. Select 3F8/IRQ4
to allow the serial port to use 3F8 as its I/O port address and IRQ 4 for the interrupt address. The
options for Serial Port1 are Disabled, 3F8/IRQ4, 3E8/IRQ4, 2E8/IRQ3. The options for Serial Port2
are Disabled, 2F8/IRQ3, 3E8/IRQ4, and 2E8/IRQ3.