Filter
Top Products
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2005 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7189
1U Rackmount System
2-5 Checking the Motherboard Setup
After you install the server in the rack, you will need to open the unit to make sure the serverboard is prop-
erly installed and all the connections have been made.
Removing the Chassis Cover (Figure 2-5)
1. Grasp the two handles on either side and pull the unit straight out until it locks (you will hear a "click").
2. Remove the screws securing the top cover to the chssis.
3. Slide the cover toward the rear of the chassis.
4. Lift the cover off the chassis.
Checking the Components
1. You should have one or two processors already installed into the serverboard. Each processor needs
its own heatsink. See Chapter 5 for instructions on processor and heatsink installation.