Filter
Top Products
3-5
Installing the AMM-1570/1572
AMM-1570/1572 User’s Guide
Stock Number: 510526-00, Rev. B Page: 3-5
Print Spec Number: 492379-00
Current Date: 3/7/94 ECN Date: 3/8/94
12 Install Adaptec software to configure your operating environ-
ment for SCSI and audio operation.
To completely install all the software necessary to operate the
AMM-1570/1572, run the Adaptec EZ-SCSI program; a series
of screens guide you through SCSI and audio configuration.
See Installing Adaptec Software on page 3-19, for information on
software available for the AMM-1570/1572.
Detailed Installation
This section is intended primarily for users who are new to SCSI
peripherals, or have limited experience in installing an option board
in their computer. Experienced users may want to refer to Quick
Installation on page 3-3.
The comprehensive instructions in this section guide you through
installing the host adapter, cabling peripherals, and connecting
audio equipment.
Note: Before physically installing the board, verify that
SCSI termination, SCSI ID setting, and jumper block con-
figuration are properly configured on the AMM-1570/
1572. Once the AMM-1570/1572 is installed in your
computer it is very difficult to change these settings.
Chapter 2, Configuring the AMM-1570/1572, describes
termination, SCSI ID, and configuration in detail.
To assist you with installation, Figure 3-1 shows the location of all
the connectors on the host adapter.
Figure 3-1. Connectors on the Host Adapter
LED Connector
Floppy Drive
Connector
(AMM-1572 Only)
Internal
SCSI
Connector
External
SCSI
Connector
Headphones/
Speakers
Line In
Line Out
Microphone
Joystick/
MIDI Port
CD Audio Input
Connector