Filter
Top Products
4-8
AMM-1570/1572 User’s Guide
AMM-1570/1572 User’s Guide
Stock Number: 510526-00, Rev. B Page: 4-8
Print Spec Number: 492379-00
Current Date: 3/7/94 ECN Date: 3/8/94
Unable to open ASPI manager!
No ASPI manager is loaded. Be sure that
aspi2dos.sys
is listed before
aspidisk.sys
in the
config.sys
file. Be sure that the ASPI drivers are in
the root directory of the boot drive. You can also put the drivers in a
subdirectory, as long as you specify a correct path in the
config.sys
file. For example, if you put the drivers in a subdirectory called
c:\drivers
, then you need the following line in your
config.sys
file:
device=c:\drivers\aspi2dos.sys
Invalid DOS version. DOS must be version 3.21 and above.
aspidisk.sys
requires MS
®
-DOS or PC-DOS 3.21 or higher. It does
not load if it detects an earlier version of DOS.
Other Error Messages
Host adapter at port address
xxx
failed diagnostics.
xxx = the port address. This message indicates that there is no host
adapter at that port address, that there is an address conflict, or that
the host adapter is defective. Reinstall the host adapter. Check cables
and jumpers. Check for I/O address conflicts. Confirm that the con-
tents of the motherboard CMOS are set correctly with the
Setup
program.
Failed scanning for SCSI devices.
The driver failed when scanning the SCSI bus for SCSI devices. Be
sure that the SCSI drive’s jumpers for SCSI ID and LUN are set cor-
rectly. Be sure that all SCSI devices are powered up. Check SCSI bus
termination, SCSI parity, and cabling.
Get device type failed
Check with your drive manufacturer to ensure that you have the
latest firmware for your SCSI drive.
Get number of heads failed
Read SCSI drive capacity failed
If the driver is unable to determine capacity for drives 0 through 7,
contact the drive manufacturer. Low-level formatting may be needed.
Failed to read master boot record
Failed to read boot record
This indicates problems reading records off the disk. Check SCSI
cabling.
❒