Filter
Top Products
4-6
AMM-1570/1572 User’s Guide
AMM-1570/1572 User’s Guide
Stock Number: 510526-00, Rev. B Page: 4-6
Print Spec Number: 492379-00
Current Date: 3/7/94 ECN Date: 3/8/94
The system is having difficulties using a SCSI drive as drive
D
and
another SCSI drive as drive
C.
■ Make sure that both standard hard disks are set to Not Installed
or No Drive Installed with your CMOS
setup
program.
■ Make sure the SCSI drive used as drive D is set to SCSI ID 1.
Check your drive manual for information on setting the SCSI
ID for that device.
■ Make sure SCSI parity is consistently enabled or disabled on
all devices on the SCSI bus.
■ Make sure SCSI termination is properly set on the host adapter
and SCSI devices.
■ If your system is running under DOS, make sure that the disk
has a DOS partition.
The system works erratically; it hangs, or the host adapter cannot
locate the drives.
■ Make sure SCSI parity is consistently enabled or disabled on
all devices on the SCSI bus.
■ Make sure SCSI termination is set correctly on the host adapter
and the peripherals.
■ Check cable length and integrity. Total cable length should be
no longer than 6 meters for the entire SCSI bus. If Fast SCSI
Operation is enabled, total cable length should be no longer
than 3 meters for the entire SCSI bus.
Playing audio CDs from your CD-ROM drive works fine in DOS, but
when trying to play audio CDs while in Windows, you get a message
similar to
NO CD ROM FOUND....
■ The [MCI] CD Audio driver is needed in order to play audio
CDs while in Windows. Use the Drivers option in Control
Panel to install the [MCI] CD Audio driver.