Filter
Top Products
Setting the Enclosure ID
37
Chapter 3: JBOD Configurations
This Chapter describes the procedure for connecting your
2Gb SANbloc Series JBOD system to a host computer(s).
Detailed information on how to configure and daisy chain
enclosures is also provided along with instructions on how
to set the enclosure ID.
Setting the Enclosure ID
Each of the fourteen disk drive slots of the 2Gb SANbloc
Series has a unique identifier assigned to it. This identifier is
assigned using a combination of the slot number and the
enclosure ID.
The enclosure ID is set using the enclosure ID switch,
located on the rear of the 2Gb SANbloc (see Figure 3-1).
Note: The enclosure ID must be set prior to powering on the
enclosure.
Note: Each enclosure must have a separate ID when daisy
chained together.
Note: 2Gb Amphenol cables must be used if 2Gb operation
is required.
Note: Only QLogic 2300 and 2310 adapters should be used.