Filter
Top Products
Installing and Removing a Power Supply
81
Installing and Removing a Power Supply
The power supplies are located in the rear of the
enclosure. Follow these procedures to install and remove the
power supplies.
Installing a Power
Supply
1 Select the power supply slot into which the power supply is to be
inserted and remove the carrier blank if there is one installed.
2 Orient the power supply, such that the LEDs are on the top (on
the right hand side for rack mount systems).
3 Gently slide the power supply into the empty power supply slot.
4 Secure in place using the two fixing screws (torque setting
0.3Nm).
5 Install the power cables.
Removing a Power
Supply
1 Turn off the power supply, and remove the power cable.
2 Loosen the two fixing screws.
3 Using the power supply handle, gently slide it out of the
enclosure.
CAUTION: Immediately replace the power supply carrier or
install a power supply carrier blank to maintain correct airflow.
Figure 6-3 Power Supply
0
I
Handle
On/Off
Switch
AC
Inlet