Filter
Top Products
RAID Controller Configurations
53
RAID Controller Configurations
This section describes how to cable the two standard RAID
controller configurations: Single RAID Controller and Dual
RAID Controller (dual active). The procedure for daisy
chaining these standard configurations to expansions enclo-
sures is also described. This section also describes how to
set the enclosure ID.
Setting the Enclosure ID
Each of the fourteen disk drive slots of the SANbloc Series
has a unique identifier assigned to it. This identifier is
assigned using a combination of the Slot number and the
enclosure ID.
The enclosure ID is set, using the enclosure ID switch,
located on the rear of the SANbloc (see Figure 4-4).
Note: The enclosure ID must be set prior to powering on the
enclosure.
Note: Each enclosure must have a separate ID when daisy
chained together.