Filter
Top Products
Installing VolServ
3-8 Post Installation Tasks 601351 Rev A
Configuring
SCSI Device
Nodes
If you are attaching a SCSI-connected library, use the following
procedures.
SGI/IRIX Host
To configure a SCSI device node to an IRIX host:
Step 1. Power-down the IRIX machine.
Step 2. Connect a properly terminated SCSI library.
Step 3. Power-up SCSI library.
Step 4. Wait for the library to finish power-up scanning.
Step 5. Power-up the IRIX host.
Step 6. Use the
hinv utility to display all devices.
Note
These steps are only required when attaching a
SCSI-connected library.
Note
These instructions do not apply to a SCSI library that is to be
controlled via the Scalar DLC network attachment.