Filter
Top Products
Installing VolServ
3-18 Post Installation Tasks 601351 Rev A
Step 2. If these printers are not attached to the VolServ host
machine serial ports A and/or B or if they are
attached to parallel ports or a remote machine, the
system administrator must set up the
/etc/printcap file to define the printers.
Step 3. To simplify the printcap file modification, use the
names of the label printers as defined in the
label_printers.config file. Otherwise,
different names used in the printcap file must also
be defined in the label_printers.config file.
Step 4. Cycle VolServ to pick up the changes.
Step 5. Cycle vswin (if open) to pick up the changes.
Configure Printers
on Solaris
Solaris only: The system administrator must use the Solaris
admintool utility to configure the label printers.
This procedure is written for an Intermec barcode label printer
attached to a Solaris server. A similar procedure can be applied
to the installation of the Seiko shelf label printer.
#
# Intermec Printer:
#
barcodelabel:\
:lp=/dev/ttyb:sd=/var/spool/lpd:\
:br#9600:ms=evenp:
# volserv -t
…
# volserv