Filter
Top Products
Section 4, Network Turnup Procedure TRACER 5045 System Manual
36 © 2003 ADTRAN, Inc. 612805045L1-1A
1. INTRODUCTION
This section discusses the installation process of the TRACER 5045 system.
2. TOOLS REQUIRED
The tools required for the installation of the TRACER 5045 are:
• VT100 terminal or PC with terminal emulation software
• RS-232 (DB-25 male for TRACER 5045) cable for connecting to terminal
3. UNPACK AND INSPECT THE SYSTEM
Each TRACER 5045 is shipped in its own cardboard shipping carton. Open each carton carefully and
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in
transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Customer
Service, Product Support Information, and Training information in the front of this manual).
Contents of ADTRAN Shipment
Your ADTRAN shipment includes the following items:
• TRACER 5045 Unit
• TRACER 5045 Quick Start Guide
• TRACER 5045 Documentation CD
Customer Provides
The following items are necessary for the installation of the TRACER 5045 system and are not provided
by ADTRAN:
• 21 to 60 VDC power source (or AC adapter available from ADTRAN P/N 1280650L1), either polarity
referenced to ground
• Antenna and mounting hardware
• Antenna feedline cable
• Ethernet cables
Changes or modifications not expressly approved by ADTRAN could void the user’s
authority to operate the equipment.
To prevent electrical shock, do not install equipment in a wet location or during a lightning
storm.