Filter
Top Products
Section 5 User Interface Guide TRACER 5045 System Manual
46 © 2003 ADTRAN, Inc. 612805045L1-1A
>TRACER SYSTEM CONFIGURATION > SITE NAME
Provides a user-defined alphanumeric description (up to 25 characters) for the TRACER 5045 system.
>TRACER SYSTEM CONFIGURATION > MODEM CONTROL
Configures the modem control leads on the RS-232 port (terminal interface located on the rear panel of the
unit). Set
MODEM CONTROL to ENABLED when connecting the unit to a modem (using a null modem
adapter). Setting
MODEM CONTROL to DISABLED prevents the TRACER 5045 from monitoring DCD and
enables data to be sent to the VT100 continuously.
MODEM CONTROL must be set to DISABLED when the
VT100 terminal is in use. The TRACER 5045 comes factory programmed with
MODEM CONTROL set to
DISABLED.
>TRACER SYSTEM CONFIGURATION > MODEM CONNECTION (LOGOUT)
Causes the TRACER 5045 to de-assert Clear To Send (CTS) and DSR for a time greater than 20 msec.
This signals the modem to disconnect the analog connection. Hangup-On-DTR-Drop may need to be
explicitly enabled on some modems. If
PASSWORD PROTECTION is ENABLED, this menu also causes the unit
to close the current session and return to the TRACER System Status menu page and wait for password
input.
>TRACER SYSTEM CONFIGURATION > PASSWORD ENABLE
Configures password protection for the VT100 terminal interface. Password protection for the
TRACER 5045 requires password input from the TRACER 5045 System Status menu page when
connecting to the unit. When configured for password protection, the TRACER 5045 closes any terminal
session that remains inactive for more than 10 minutes. The TRACER 5045 comes factory programmed
with
PASSWORD ENABLE set to DISABLED.
>TRACER SYSTEM CONFIGURATION > PASSWORD
Sets the password for password protection of the TRACER 5045 VT100 terminal interface. Enter up to 8
alphanumeric characters. The system password is case sensitive.
>TRACER SYSTEM CONFIGURATION > PERFORMANCE STATS (CLEAR)
Resets all system error counters for the TRACER 5045.
Press <Ctrl+Z> three times from the terminal interface to disable MODEM CONTROL when
the modem control leads are active.
The default password for the TRACER 5045 is tracer.