Filter
Top Products
Chapter 3. Configuration
61200217L1-1 T3SU 300 User Manual 3-17
Table 3-3. MIB II Standard Trap Descriptions
Table 3-4. Network Test Trap Descriptions
Idle Signal when the unit receives indication from the far
end unit through the FEAC channel that the far
end unit is receiving an idle signal (1100) over
the entire DS3 payload.
Eqpt. Fail
NSA
when the unit receives indication from the net-
work through the FEAC channel of a non-ser-
vice-affecting failure in the network equipment.
Eqpt. Fail SA when the unit receives indication from the net-
work through the FEAC channel of a service-af-
fecting failure in the network equipment.
Com. Eqpt.
Fail NSA
when the unit receives indication from the net-
work through the FEAC channel of a non-ser-
vice-affecting failure in the network common
equipment.
Trap Type If ENABLED, this trap is sent...
Cold Start when the unit is first powered on.
Link Up when the network recovers from a Link Down con-
dition and data transmission is restored.
Link Down when a network condition prevents data transmis-
sion. This could be either an alarm or a network
test.
Auth. Failure when an SNMP request is made with the wrong
read or write community names.
Trap Type If ENABLED, this trap is sent...
Network Test In when the unit goes into a DS3 network test, either
commanded locally or remotely.
Network Test
Out
when the unit is in a DS3 network test and the test
is terminated.
Trap Type If ENABLED, this trap is sent...