Filter
Top Products
Chapter 3. Configuration
61200217L1-1 T3SU 300 User Manual 3-21
Maximum Redial Attempts
The T3SU 300 attempts to establish a call the number of times
entered in this field. If a successful call is not established after the
final attempt, the T3SU 300 discards the trap messages.
Idle Timeout
Once a call is established and the trap messages are sent, the
T3SU 300 remains online for the amount of seconds entered in this
field. If the field is set to 0, the unit hangs up as soon as the trap is
sent.
Connection Timeout
The T3SU 300 waits for a connection the amount of seconds entered
in this field. Timing begins as soon as the dial command is issued.
Pause Between Calls
The T3SU 300 waits the number of seconds entered in this field
between redial attempts.
Dialout On Trap
Enable or disable the T3SU 300’s ability to dial out to report traps.
When the
A
UXILIARY
P
ORT
M
ODE
(product version 1200217L1) or
M
ODEM
M
ODE
(product version 1200217L2) is configured for
D
IALUP
VT 100
, the unit reports error conditions in plain ASCII with the
following information:
• The Unit ID value programmed in the Unit ID field of the
second
S
YSTEM
M
ANAGEMENT
screen (see Figure 3-9)
• A trap code indicating the error condition (selected from the
T
RAP
G
ENERATION
screen under
S
YSTEM
M
ANAGEMENT
)
• The date and time when the error was logged
When the
A
UXILIARY
P
ORT
M
ODE
or
M
ODEM
M
ODE
is configured for
D
IALUP
PPP
or
D
IALUP
SLIP
, the unit logs in to the PPP/SLIP host
and reports the error conditions to the hosts designated under the
T
RAP
IP A
DDRESSES
(also found under
S
YSTEM
M
ANAGEMENT
).