Agilent Technologies 87075C Network Router User Manual


 
Chapter 3 33
Test Set Cal and SelfCal
Test Set Cal: An Overview
The analyzer will interpolate between calibrated measurement points when the
frequency span is narrowed. However, you should be aware that best measurement
accuracy is compromised with this interpolation.
Figure 3-1 Frequency Range Example
NOTE It is recommended that you set your stop frequency to 1300 MHz. The performance
of the test set is not specified above 1300 MHz.
Using this method of calibration will yield accurate measurements with optimum
throughput. If your accuracy requirements are more important than your throughput
requirements, you may want to perform a separate Test Set Cal for each
measurement setup, which eliminates the need for the analyzer to use interpolation.