Filter
Top Products
Raven and PinPoint CDMA User Guide Version 1.12
AirLink Communications, Inc. Page 47 March 24, 2004
Command
Description
S50=n [?]
Set or query data forwarding idle timeout. n = tenths of seconds.
(Used in UDP or TCP PAD mode)
S51=n [?]
Set or query PAD data forwarding character.
n = 0: no forwarding character
n = other: ASCII code of character that causes data to be
forwarded.
(Used in UDP or TCP PAD mode.)
S53=
[method]d.d.d.d[/ppppp] [?]
Set or query Destination IP address, port, and method. These are
used as defaults for the D (Dial) AT command.
method =
P – UDP
T – TCP
N – Telnet
d.d.d.d = IP address
ppppp = the port address
ATS53=T192.168.100.23/12345
ATS53=192.168.100.23/12345
ATS53=/12345
S60=n [?]
Telnet Client Echo Mode
n = 0: No Echo
n = 1: Local Echo (Default)
n = 2: Remote Echo
S82=n [?]
Enables UDP auto answer (half-open) mode.
n = 0: Normal mode
n = 2: Enable UDP auto answer mode.
S83=n [?]
Set or query UDP auto answer idle timeout. If no data is sent or
received before the timeout occurs, the current UDP session will be
terminated. While a session is active, packets from other IPs will
be discarded (unless *UALL is set).
n = 0: No idle timeout (Default).
n = 1-255: Timeout in seconds.
S110=d.d.d.d[/ppppp] [?]
Used to query or set IP address and port for CDPD modems, or only
sets the modem’s Device Port for CDMA and GPRS modems.
Since the IP address is determined from the CDMA and GPRS
networks, any specified address will be ignored.
If S300=0 you will get the network IP when you query this value. If
S300=1 you will get the private IP address.
d.d.d.d = IP address
ppppp = port number
NOTE: See also S300,*DPORT
S202?
Queries the current RSSI in dBm