Filter
Top Products
Raven and PinPoint CDMA User Guide Version 1.12
AirLink Communications, Inc. Page 50 March 24, 2004
Command
Description
*CTSE=n [?]
Clear To Send Enable
This feature asserts CTS when there is a network connection.
Note: Flow control (AT\Q) will override this indication, so if you
want to use CTS to indicate network coverage, flow control has to
be off (AT\Q0).
RS232 voltage levels: Positive = Network coverage, Negative = no
coverage.
n = 0: Disabled (Default).
n = 1: Enable assertion of CTS when there is network coverage.
*DATE=[mm/dd/yyyy],[hh:
mm:ss] [?]
Sets and queries the clock in the unit. Either the date and time can
be specified, or simply one of the two can be specified in which case
the unspecified value will remain unchanged. The date and time
are always specified in UTC (Universally Coordinated Time) and,
as such, the hours are specified in 24-hours format.
Note that if the product has a GPS (i.e. PinPoints), the GPS will be
used to set the time, in which case any date/time specified will be
ignored.
*DATZ=n [?]
Enables or disables reset on ATZ
n = 0: Normal Reset (Default).
n = 1: Disable Reset on ATZ.
*DBGIPLVL=n [?] Sets the logging level for the IP subsystem.
n = 0: No logging
n = 1: Log errors (i.e. invalid/corrupt packets, etc.).
n = 2: Log the header of all received packets. Note that this can
quickly exhaust the event log.
*DBGPPPLVL=n [?] Sets the logging level for the PPP stack.
n = 0: No logging
n = 1-3: Enables logging at different levels of detail.
*DEVICEID=n [?]
Sets or queries the 64-bit Device ID that is used by the modem to
identify itself to the server. The default is a value that depends on
the underlying communications technology being used.
*DEVICEIDX=n [?]
Same as *DEVICEID except entry of the 64-bit Device ID is in
hexadecimal.
*DNSn=d.d.d.d
Sets the DNS addresses to be returned during PPP negotiation. If
the underlying communications network provides DNS addresses,
they replace those specified by this command. *DNS1 and *DNS2
are valid.