Airlink Raven and PinPoint CDMA Network Card User Manual


 
Raven and PinPoint CDMA User Guide Version 1.12
AirLink Communications, Inc. Page 55 March 24, 2004
10 Raven Installation
This section details the hardware specs of the Raven and mounting it with other
hardware, the power requirements, mounting bracket, etc.
Mounting the Raven
The Raven should be mounted in a position that allows easy routing and access for
the cables. There should be no binding or sharp corners in the cable routes. The
Raven should be mounted so that the LEDs on the front panel can be easily seen for
ease of operational verification.
The snap-in mounting bracket (part number 100-170-1006) is installed using #8 or
#10 screws. Press the Raven down firmly into the bracket and note that both sides
have locked into the groove on the Raven case.
Figure 1 - Raven Mounted in Mounting Bracket
Note:
The tie-wrap is if the modem needs to be really secure, as in a vehicle or in
shipping. In stationary applications, as in a box that sits out in a pasture with a solar
cell, etc., the tie-wrap is not necessary.