Filter
Top Products
Raven and PinPoint CDMA User Guide Version 1.12
AirLink Communications, Inc. Page 54 March 24, 2004
Command
Description
*UALL=n [?]
Accepts UDP packets from any IP address when a UDP session is
active. If there is no UDP session active, an incoming UDP packet
will be treated according to the UDP auto answer and AIP settings.
n = 0: No effect (Default).
n = 1: Accept UDP data from all IP addresses when in a UDP
session.
*UDPLAST=n [?]
If enabled, sets S53 to the last accepted IP address through UDP
auto answer. This can be used in conjunction with MD3 so that
when there is no UDP session, new serial host data will cause a
connection to be restored to the last IP accepted through UDP auto
answer.
n = 0: Does not change S53 setting. (Default).
n = 1: Set S53 to the last accepted IP.
NOTE: This does not change the S53 setting in NVRAM. If the
modem is reset, the original S53 setting will be restored from
NVRAM.
*USD=n [?]
Inserts a delay between received UDP packets by a specified
interval before sending them out to the serial port.
n = 0: No UDP packet delay (Default).
n = 1-255: Delay in 100ms units, from 100 ms to 25.5 sec.