Filter
Top Products
www.aleratec.com
12
Using the HDD PortaCruiser
Loading the Hard Drives
IDE Drives
Use an IDE cable (not included) to connect the source/target hard drive’s IDE 1.
port to the HDD PortaCruiser’s Source/Target IDE port.
Use an IDE cable (not included) to connect the source/target hard drive’s power 2.
port to the HDD PortaCruiser’s Source/Target port.
SATA Drives
Position the HDD PortaCruiser on a at surface with enough area around it to 1.
place the source/target hard drive.
Align the source/target hard drive’s SATA port with the HDD PortaCruiser’s 2.
SATA connector.
Slide the source/target hard drive against the HDD PorrtaCruiser so that the 3.
SATA connection is made.
Note: If you are duplicating, the hard disk drive you are copying goes on the side
labeled “Source”, and the hard disk drive you are copying to goes on the side
labeled “Target”.
Note: When both the IDE and SATA connectors on the Target (or Source) side are
connected to hard drives, the HDD PortaCruiser will only recognize the SATA drive.