Filter
Top Products
www.aleratec.com
14
Using the HDD PortaCruiser
Duplicator Mode
Main Menu: Copy HDD
The “Copy HDD” function performs an actual copy from the source HDD to the target
HDD. The target HDD must be at least as large as the source. The HDD PortaCruiser
will copy every block of capacity on the source HDD.
Load the source HDD and the target HDD into the HDD PortaCruiser. The system 1.
will auto-detect the hard drives. After the drives have been detected, a screen
similar to the one below will be displayed.
Note: Before copying be sure that the capacity of the target HDD is equal to or
larger than the source hard drive.
Press 2. ENT to start copying. The system will auto-detect the hard drives. The
following information will be displayed.
During the copy process the HDD PortaCruiser will display progress information.3.
The amount of data remaining to be transferred (shown in gigabytes), and time
will be displayed in decreasing increments as the percentage of completion
increases.
Note: The copying speed, capacity and duration may vary from one source hard
drive to another.
Once duplication is complete, a job status screen will be displayed.4.
ENT
1. Copy HDD
149.1GB
ESC
RESET
MUTE
ENT
Detect Drives
Please wait...
ESC
RESET
MUTE
ENT
Copy - 36MB/s 0%
235.7GB 1:48
ESC
RESET
MUTE
ENT
1. HDD
OK:1 Fail: 0
ESC
RESET
MUTE