Filter
Top Products
www.aleratec.com
49
Specifications
Power Requirements Voltage: 100-240V
Current: 50-60Hz
Dimensions
(depth x width x height)
D: 150mm W: 116mm H: 27mm
(5.9” x 4.6” x 1.0”)
Weight 235g (0.5 Lbs.)
Note: Specifications subject to change without notice.
Troubleshooting
If your HDD PortaCruiser is not performing as expected, refer to the symptoms
below, and follow the suggested corrective action.
Symptoms Corrective Actions
LCD Display If the LCD display does not display any message and
the backlight is not lit after powering on the HDD
PortaCruiser, check that the power cable is properly
connected and that the ON/OFF switch is turned on.
Error Messages While the system is performing an operation and the
operation is manually terminated, an error message will
be shown in the LCD display. This may lead to an failed
operation and could cause the HDD PortaCruiser to stop
responding. If this happens, power the unit off, wait about
ten (10) seconds, and then reapply power.
Hard Disk If the HDD PortaCruiser does not detect one of the hard
disk drives, verify that the drive is properly connected.
Keypad Buttons If pressing the keys on the front panel produces no
response from the system, the HDD PortaCruiser may still
be busy with the previous operation. If the system idle,
power the unit off, wait about ten (10) seconds, and then
reapply power.
Startup/Shutdown Do not power off the system while it is performing an
operation. After a normal shutdown, wait about ten (10)
seconds before reapplying power.