Filter
Top Products
14 Software Release Note AlliedWare Plus Version 5.4.3-0.1 C613-10508-01-REV B
channel-group Modified Y Y Y Y Y Link
Aggregation
Commands
Use this command to add a switch port to a
dynamic channel group. The behavior of the
no channel-group command has
changed. The no channel-group
command now turns off link aggregation on
the switch port and returns to Global
Configuration mode from Interface
Configuration mode.
ipv6 mld New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to enable the MLD
protocol operation on an interface. This
command enables MLD protocol operation in
stand-alone mode, and can be used to learn
local-membership information prior to
enabling a multicast routing protocol on the
interface.
ipv6 mld
immediate-
leave
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to minimize the leave
latency of MLD memberships.
ipv6 mld last-
member-
query-count
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to set the last-member
query-count value.
ipv6 mld last-
member-
query-interval
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to configure the interval at
which the router sends MLD group-specific
host query messages.
ipv6 mld
querier-
timeout
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to configure the timeout
period before the router takes over as the
querier for the interface after the previous
querier has stopped querying.
ipv6 mld
query-interval
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to configure the frequency
of sending MLD host query messages.
ipv6 mld
query-max-
response-time
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to configure the maximum
response time advertised in MLD queries.
ipv6 mld
robustness-
variable
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to change the robustness
variable value on an interface.
ipv6 mld
snooping
querier
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to enable MLD querier
operation on a subnet (VLAN) when no
multicast routing protocol is configured in
the subnet (VLAN). When enabled, the MLD
Snooping querier sends out periodic MLD
queries for all interfaces on that VLAN.
Table 4: New and modified commands in 5.4.3
Command Status
x510
x610
x900
x908
x8112
Software
Reference
Chapter Description