Filter
Top Products
C613-10508-01-REV B Software Release Note AlliedWare Plus Version 5.4.3-0.1 21
show ipv6 pim
sparse-mode
mroute
New N Y Y Y Y PIM-SMv6
Commands
Use this command to display the IPv6
multicast routing table, or the IPv6 multicast
routing table based on the specified IPv6
address or addresses.
show ipv6 pim
sparse-mode
mroute detail
New N Y Y Y Y PIM-SMv6
Commands
Use this command to display detailed entries
of the IPv6 multicast routing table, or detailed
entries of the IPv6 multicast routing table
based on the specified IPv6 address or
addresses.
show ipv6 pim
sparse-mode
neighbor
New N Y Y Y Y PIM-SMv6
Commands
Use this command to show the PIM-SMv6
neighbor information.
show ipv6 pim
sparse-mode
nexthop
New N Y Y Y Y PIM-SMv6
Commands
Use this command to see the nexthop
information as used by PIM-SMv6.
show ipv6 pim
sparse-mode
rp mapping
New N Y Y Y Y PIM-SMv6
Commands
Use this command to show group-to-RP
(Rendezvous Point) mappings, and the RP set.
show ipv6 pim
sparse-mode
rp nexthop
New N Y Y Y Y PIM-SMv6
Commands
Use this command to display the RP
(Rendezvous Point) nexthop information
used by PIM-SMv6.
show ipv6 pim
sparse-mode
rp-hash
New N Y Y Y Y PIM-SMv6
Commands
Use this command to display the Rendezvous
Point (RP) to be chosen based on the IPv6
group address selected.
undebug all
ipv6 pim
sparse-mode
New N Y Y Y Y PIM-SMv6
Commands
Use this command to disable all PIM-SMv6
debugging.
undebug ipv6
pim sparse-
mode
New N Y Y Y Y PIM-SMv6
Commands
Use this command to deactivate PIM-SMv6
debugging. Note this command is an alias of
the no variant of the debug ipv6 pim
sparse-mode command.
power-inline
allow-legacy
Modified N Y N N N Power over
Ethernet
Commands
This command was available from the
Interface Configuration mode prompt
(awplus(config-if)) and is now available from
the Global Configuration command mode
prompt (awplus(config)).
show mls qos
interface
policer-
counters
New Y Y Y Y Y QoS
Commands
Use this command to display an interface’s
policer counters. This can either be for a
specific class-map or for all class-maps
attached to the interface. If no class-map is
specified all class-map policer counters
attached to the interface will be displayed.
Command output has changed for 5.4.3
release. See full description and usage notes
for this command in the QoS Commands
chapter.
ipv6 rip metric-
offset
New N Y Y Y Y RIPng
Commands
Use this command to set the amount that
should be added to the metric of routes
learnt by RIP via this interface.
snmp-server
startup-trap-
delay
New Y Y Y Y Y SNMP
Commands
Use this command to set the time, in seconds,
after completion of the switch startup
sequence before the switch sends any SNMP
traps or notifications. Use the no variant of
this command to restore the default startup
delay of 30 seconds.
Table 4: New and modified commands in 5.4.3
Command Status
x510
x610
x900
x908
x8112
Software
Reference
Chapter Description