Filter
Top Products
C613-10508-01-REV B Software Release Note AlliedWare Plus Version 5.4.3-0.1 15
ipv6 mld
version
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to set the current MLD
protocol version on an interface.
show
debugging
mld
New Y Y Y Y Y MLD and MLD
Snooping
Introduction
and
Commands
Use this command to display the MLD
debugging modes enabled with the debug
mld command.
clear ipv6
mroute
New Y Y Y Y Y Multicast
Introduction
and
Commands
Use this command to delete entries from the
IPv6 multicast routing table.
clear ipv6
mroute
statistics
New Y Y Y Y Y Multicast
Introduction
and
Commands
Use this command to delete multicast route
statistics entries from the IPv6 multicast
routing table.
clear ipv6
multicast route
New Y Y Y Y Y Multicast
Introduction
and
Commands
Use this command to delete all IPv6 static
multicast routes from the IPv6 multicast
routing table configured with the ipv6
multicast route command.
debug nsm
mcast6
New Y Y Y Y Y Multicast
Introduction
and
Commands
Use this command to debug IPv6 events in
the Multicast Routing Information Base
(MRIB).
ipv6 multicast
route
New Y Y Y Y Y Multicast
Introduction
and
Commands
Use this command to add an IPv6 static
multicast route for a specific multicast source
and group IPv6 address to the multicast
Routing Information Base (RIB). This IPv6
multicast route is used to forward IPv6
multicast traffic from a specific source and
group ingressing on an upstream VLAN to a
single or range of downstream VLANs.
ipv6 multicast
route-limit
New Y Y Y Y Y Multicast
Introduction
and
Commands
Use this command to limit the number of
multicast routes that can be added to an IPv6
multicast routing table.
ipv6 multicast-
routing
New Y Y Y Y Y Multicast
Introduction
and
Commands
Use this command to turn on/off IPv6
multicast routing on the router; when turned
off the device does not perform Layer-3
multicast functions.
show ipv6 mif New Y Y Y Y Y Multicast
Introduction
and
Commands
Use this command to display the contents of
the IPv6 Multicast Routing Information Base
(MRIB) MIF table.
show ipv6
mroute
New Y Y Y Y Y Multicast
Introduction
and
Commands
Use this command to display the contents of
the IPv6 multicast routing (mroute) table.
neighbor Modified N Y Y Y Y OSPF
Commands
Use this command to inform the router of
other neighboring routers that are connected
to the same NBMA network. Poll interval
range changed from <1-65535> to <1-
2147483647>.
Table 4: New and modified commands in 5.4.3
Command Status
x510
x610
x900
x908
x8112
Software
Reference
Chapter Description