Filter
Top Products
18 Software Release Note AlliedWare Plus Version 5.4.3-0.1 C613-10508-01-REV B
summary-
address
New N Y Y Y Y OSPFv3 for
IPv6
Commands
Use this command in Router Configuration
mode to summarize, or possibly suppress,
external redistributed OSPFv3 routes within
the specified address range. The no variant of
this command stops summarizing or
suppressing routes within an address range.
clear ipv6
mroute pim
New N Y Y Y Y PIM-SMv6
Commands
Use this command to clear all Multicast
Forwarding Cache (MFC) entries in PIM-SMv6.
clear ipv6
mroute pim
sparse-mode
New N Y Y Y Y PIM-SMv6
Commands
Use this command to clear all multicast route
table entries learned through PIM-SMv6 for a
specified multicast group address, and
optionally a specified multicast source
address.
clear ipv6 pim
sparse-mode
bsr rp-set *
New N Y Y Y Y PIM-SMv6
Commands
Use this command to clear all Rendezvous
Point (RP) sets learned through the PIM-SMv6
Bootstrap Router (BSR).
debug ipv6
pim sparse-
mode
New N Y Y Y Y PIM-SMv6
Commands
Use this command to activate PIM-SMv6
debugging.
debug ipv6
pim sparse-
mode packet
New N Y Y Y Y PIM-SMv6
Commands
Use this command to activate PIM-SMv6
packet debugging.
debug ipv6
pim sparse-
mode timer
New N Y Y Y Y PIM-SMv6
Commands
Use this command to enable debugging for
the specified PIM-SMv6 timers.
ipv6 pim
accept-register
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure the ability to
filter out multicast sources specified by the
given software IPv6 access-list at the
Rendezvous Point (RP), so that the RP will
accept/refuse to perform the register
mechanism for the packets sent by the
specified sources. By default, the RP accepts
register packets from all multicast sources.
ipv6 pim
anycast-rp
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure Anycast RP
(Rendezvous Point) in an RP set.
ipv6 pim bsr-
border
New N Y Y Y Y PIM-SMv6
Commands
Use the ipv6 pim bsr-border
command to prevent Bootstrap Router (BSR)
messages from being sent or received
through a VLAN interface. The BSR border is
the border of the PIM-SMv6 domain.
ipv6 pim bsr-
candidate
New N Y Y Y Y PIM-SMv6
Commands
Use this command to make the device a BSR
(Bootstrap Router) candidate using the
specified IPv6 address of the interface.
ipv6 pim cisco-
register-
checksum
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure the option to
calculate the Register Checksum over the
whole packet. This command is used to inter-
operate with older Cisco IOS versions.
ipv6 pim cisco-
register-
checksum
group-list
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure the option to
calculate the Register Checksum over the
whole packet on multicast groups as
specified by the software IPv6 access-list. This
command is used to inter-operate with older
Cisco IOS versions.
Table 4: New and modified commands in 5.4.3
Command Status
x510
x610
x900
x908
x8112
Software
Reference
Chapter Description