Filter
Top Products
C613-10508-01-REV B Software Release Note AlliedWare Plus Version 5.4.3-0.1 19
ipv6 pim crp-
cisco-prefix
New N Y Y Y Y PIM-SMv6
Commands
Use this command to interoperate with Cisco
devices that conform to an earlier draft
standard. Some Cisco devices might not
accept candidate RPs with a group prefix
number of zero. Note that the latest BSR
specification prohibits sending RP
advertisements with prefix 0.
ipv6 pim dr-
priority
New N Y Y Y Y PIM-SMv6
Commands
Use this command to set the Designated
Router priority value.
ipv6 pim
exclude-genid
New N Y Y Y Y PIM-SMv6
Commands
Use this command to exclude the GenID
option from Hello packets sent out by the
PIM-SMv6 module on a particular interface.
This command is used to inter-operate with
older Cisco IOS versions.
ipv6 pim ext-
srcs-directly-
connected
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure PIM-SMv6 to
treat multicast traffic from any source arriving
on the interface as though it was sent from a
host directly connected to the interface.
ipv6 pim hello-
holdtime
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure a hello-
holdtime value. You cannot configure a hello-
holdtime value that is less than the current
hello-interval.
ipv6 pim hello-
interval
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure a hello-
interval value for PIM-SMv6.
ipv6 pim
ignore-rp-set-
priority
New N Y Y Y Y PIM-SMv6
Commands
Use this command to ignore the RP-SET
priority value, and use only the hashing
mechanism for RP selection.
ipv6 pim jp-
timer
New N Y Y Y Y PIM-SMv6
Commands
Use this command to set the PIM-SMv6 join/
prune timer. Note that the value set by the
join/prune timer is the value that the switch
puts into the holdtime field of the join/prune
packets it sends to its neighbors.
ipv6 pim
neighbor-filter
New N Y Y Y Y PIM-SMv6
Commands
Use this command to enable filtering of
neighbors on the VLAN interface. When
configuring a neighbor filter, PIM-SMv6 will
either not establish adjacency with the
neighbor, or terminate adjacency with the
existing neighbors if denied by the filtering
IPv6 access list.
ipv6 pim
register-rate-
limit
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure the rate of
register packets sent by this DR, in units of
packets per second. The configured rate is per
(S, G) state, and is not a system wide rate.
ipv6 pim
register-rp-
reachability
New N Y Y Y Y PIM-SMv6
Commands
Use this command to enable the RP
reachability check for PIMv6 Register
processing at the DR. The default setting is no
checking for RP-reachability.
ipv6 pim
register-source
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure the source
IPv6 address of register packets sent by this
DR. This value overrides the default source
IPv6 address, which is the IPv6 address of the
RPF interface toward the source host.
ipv6 pim
register-
suppression
New N Y Y Y Y PIM-SMv6
Commands
Use this command to configure the register-
suppression time, in seconds, overriding the
default of 60 seconds.
Table 4: New and modified commands in 5.4.3
Command Status
x510
x610
x900
x908
x8112
Software
Reference
Chapter Description