Filter
Top Products
16-EN
01GB07TMEM860_US_EN.fm
ALPINE TME-M740BT_US (EN)
Installation
Accessory List
1
Remove the main unit attachment fitting.
2
Loosen the main unit attachment fitting with a coin
etc., slide it into the track on the rear of the main unit
and temporarily fasten it. Then fix it to the stand.
3
Check the sticking position.
4
Remove the main unit from the stand.
Attaching the monitor and stand
CAUTION
Do not install the monitor near the front passenger
seat air bag system.
Monitor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Display cable (2.5m)/Power Cable. . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Cord clamp. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Monitor stand. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Fixing Screw (M4×12). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Cloth. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Bracket Center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Bracket Side (L/R) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Screw (M5×8) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Owner's Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Pull this part to release.
Main unit
attachment fitting
Slide in an
upward direction.
In order to use safely, attach to the following places.
• Stable and secure places.
• Places that will not have your view blocked by the main
unit when driving.
• Places that you will not hit against if you lean forward
while you wearing your seatbelt.
• Places where the main unit cannot hit against the steering
wheel while driving.
• Be aware that if the surface of the dashboard is leather, wooden
panel, stretched fabric or any non-resin based product, then the
surface will be damaged when you remove the stand.
• Do not place the main unit directly in front of the air conditioner
vents.
The fixed arm tilts towards the seat side.
Angle
adjustment
screw
Seat side Front glass side
ATemporarily fasten the stand with gum tape.
BLoosen the adjustment screws, and adjust to a safe,
viewable position.
Main unit
Line of sight
Dashboard
If the main unit
invades your line
of sight then it will
block your view.
01GB00TMEM860_US_EN.book Page 16 Wednesday, December 13, 2006 2:23 AM